During operation, the motor of Spring Cone Crusher Crushes drives the eccentric shaft shell to turn around through ahorizontal axle and a pair of bevel gear. The axle of crushing cone swings with the force of eccentric shaft shell so that the surface of the crushing wall is close to the roll mortar wall from time to time. In this way, the ores and rocks will be pressed and crooked and crushed.

[

Installation of Spring Cone Crusher thrust bearing

]

To ensure the precision of thrust bearing installation in spring cone crusher, installation must be the following steps:
(1) the installation of the thrust bearing should be same to steps of scratching.
(2) first, jaw plate placed in a case back should be smooth,if case back has the burr and the remaining sand,please clean up.Then pour lubricating oil to just the top of jaw plate.
(3) then install the middle circle plate and circle plate
(4) Finally, install the air eccentric shaft, spherical tile racks, and spindle. When installing air eccentric shaft,the big gear weight should be placed in the top of small gear,so that the outer end of bevel gear is alignment.After spherical waham installed, the gap between spherical bearing seat and the main machine is as big as possible.During installation, measure the three data: a. gap of cone gear; b. gap between principal axis and spindle sleeve; c. gap between empty eccentric shaft and spherical waham.